Avtech 717ZC Manuel d'utilisateur télécharger pdf (Page 7)

QUICK INSTALLATION

Page 6

Install the supplied AP software on your NB/PC. Then, log into the DVR with the supplied AP software for the following

default DVR settings.

‧ The DVR default IP address: 192.168.1.10

‧ The DVR default account / password: admin

‧ The DVR default port: 80

2) Set DVR network setting in “SYSTEM CONFIG” → “Network” of the supplied AP:

In “SYSTEM CONFIG” → “Network” of the supplied AP, select the “Static IP” in “IP TYPE” section. And then type the

“Server IP”, “Gateway”, “Net Mask” and “Web Port” (1~9999) information obtained from your ISP. Press ”APPLY” button

to confirm the setting.

3) Login your DVR via an Ethernet or dial-up network:

After setting up the network information of the DVR and connect it to the network, you can use the IP address / Port /

Account / Password you just entered in the supplied AP software to log into your DVR remotely.

Note: Before changing the network properties of your PC/NB, please write down the original network

properties in case you need to recover the properties later.

3.6.2 DDNS Apply

You need to apply a DDNS account before setting PPPoE or DHCP connection. DDNS is a service for transforming

the dynamic IP corresponding to a specific “Hostname”. For DDNS setup, please refer to the steps below.

‧ Go to a website which provides free DDNS services and apply a “Hostname”.

For example, go to

http://www.dyndns.com.

‧ Enter all the information necessary for signing up an account according to the website instructions.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Avtech 717ZC Manuel d'utilisateur Page 7