Avtech AVH306 Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 138
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
CONNECTION
2
2. CONNECTION
2.1 Hard disk installation
The product appearance may vary from the picture shown below for different models; here take the 6CH model for
example:
Step1: Remove the top cover.
Step2: Find the hard disk bracket in the NVR, and place the compatible hark disk in the bracket.
Step3: With the PCB side facing up, connect the hard disk to the power connector and data connector.
Step4: Fasten the hark disk with the supplied screws, two for each side.
Step5: To install another hard disk, find the supplied hard disk brackets in the package, and fix them onto the NVR
base.
Step6: With the PCB side facing up, connect the hard disk to the power connector and data connector.
Step7: Then, put the hard disk in the bracket, and fasten it with the supplied screws, two for each side.
Step8: Replace the top cover and fasten the screws you loosened in Step1.
Note: Before remote firmware update, please install a HDD into your NVR first to make sure the
firmware update works properly.
Note: It’s not recommended to use a green HDD with your NVR to make sure it works properly.
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 137 138

Commentaires sur ces manuels

Pas de commentaire